For sale locally so listing may end prematurely. Pre inlet for THOMPSON CENTER HAWKEN Barrel, tang, lock, and trigger only and trigger guard ONLY. Renegade barrel, tang, lock, and trigger, and trigger guard will fit also. Inlet for 15/16 -inch barrel, lock and trigger only. 9 If using a renegade Barrel will need some inletting of barrel channel. Not inlet for patch box allowing your choice of no box or any custom Patch box. Extra-long in butt for trigger pull adjustment. Figure in most all of the stock. If I was to put a percentage, I would say 95 plus of the stock is s tr iped. This is known as a grade 4 extra fancy maple stock. Mildly oversized for finish and or carving. This is not a plug and play part. You will need to do minor inletting adjustments, sanding and fitting of all parts. To get perfect fit. This T/C Hawken rifle stock is cut for the standard 15/16 barrel found on. 50 caliber factory assembled Thompson Center Hawken Rifles. In addition to the barrel, the tang, lock, double set triggers, and oval inlays are pre-inlet. This extra-long stock may be cut to fit your Butt plate. Not cut for T/C’s unique brass capbox, this stock may be fitted with T/C’s percussion or flint lock and plug. Adjust pull length up to 16″, with up to 3 3/4″ drop. Typically, less if you install butt plate and shorten the butt area in anyway. Typically, this project requires about 20 to 30 hours average if it is your first such project. You must scrape in the final inletting at the tight spots, using inlet black or candle soot or something similar lipstick??? That is non staining and removable. You must drill pilot holes for the wood screws, et cetera. And you must shape, sand, and stain the stock to a smooth fine finish. This is wood, a natural product with possible imperfections, realize this! Sanding, cutting or modification to this stock blank can change what is seen by the eyes. Drop is 3 3/4 max will be less if stock is shortened to adjust trigger pull. Toe to heel 4 3/4. Butt width is 1 1/2 Approximate. Pull is adjustable 16 inch max approximate. Barrel channel is 14 3/8 long and 15/16 wide approximate. Forearm length is longer that factory by about 1/2 – 3/4 inch to allow nose cap to under rib adjustments. Lock mortise is for T/C lock both flint and cap. Inlet for wedge plate, not barrel lug or wedge pin. For Thompson Center Only cannot tell you if can be used with others. Which is more than I get % wise and I bear cost of packing. Therefore, I cannot entertain Offers on this item. Sorry margin is slim.
Categories: thompson
Related Topics: center, extra, fancy, hawken, inlet, maple, shaped, stock, thompson